CURT 55326 Προσαρμοσμένη πλεξούδα καλωδίωσης τρέιλερ 4 ακίδων Vehicle-Side, Ταιριάζει σε Select Ford Crown Victoria, Ford Mustang, Mercury Grand Marquis , Μαύρο

Brand:CURT

3.3/5

Ft
70.29

Εάν το όχημά σας δεν είναι εξοπλισμένο με καλωδιώσεις για τη ρυμούλκηση τρέιλερ, η προσαρμοσμένη καλωδίωση CURT είναι η ιδανική λύση. Μια προσαρμοσμένη πλεξούδα καλωδίωσης -- που ονομάζεται επίσης βύσμα T -- είναι μια απλή ηλεκτρική συσκευή plug-and-play που συνδέεται στο ηλεκτρικό σύστημα του αυτοκινήτου σας και παρέχει μια τυπική, καθολική σύνδεση καλωδίωσης τρέιλερ. Αυτό γίνεται με χρήση δύο ή περισσότερων συνδετήρων συμβατών με OEM ειδικά για το όχημα για σύνδεση στο συγκρότημα του πίσω φανού, εξαλείφοντας την ανάγκη για κοπή, μάτισμα και συγκόλληση κατά την εγκατάσταση. Οι προσαρμοσμένες καλωδιώσεις είναι ειδικά σχεδιασμένες για το όχημα και, ενώ δεν είναι διαθέσιμες για όλα τα οχήματα, προσφέρουν έναν από τους ταχύτερους, ευκολότερους και ασφαλέστερους τρόπους καλωδίωσης ενός οχήματος για ρυμούλκηση. Αυτή η συγκεκριμένη πλεξούδα πλεξούδας παρέχει μια επίπεδη υποδοχή σύνδεσης 4 κατευθύνσεων και έχει σχεδιαστεί για να είναι μια προσαρμοσμένη καλωδίωση που ταιριάζει σε ορισμένα χρόνια των Ford Crown Victoria, Ford Mustang και Mercury Grand Marquis (για να επαληθεύσετε τη συμβατότητα του οχήματός σας, δείτε πληροφορίες εφαρμογής) . Συνοδεύεται από όλα τα απαραίτητα εξαρτήματα καλωδίωσης για τη δημιουργία αξιόπιστης σύνδεσης καλωδίωσης ρυμουλκούμενου, καθώς και κάλυμμα σκόνης για να διατηρείται ο σύνδεσμος καθαρός όταν δεν χρησιμοποιείται. Έχετε στο μυαλό σας μια εικόνα του επόμενου προορισμού σας -- ίσως είναι το σκάφος που προσγειώνεται στο αγαπημένο σας σημείο ψαρέματος, ίσως είναι ένα κάμπινγκ που έχει θέα σε ένα από τα αριστουργήματα της φύσης ή ίσως είναι το επόμενο μεγάλο εργοτάξιο. Ωστόσο, η μετατροπή αυτής της εικόνας σε πραγματικότητα απαιτεί περισσότερα από μια απλή ονειροπόληση. Χρειάζεται μια σταθερή σύνδεση και τη σωστή ποσότητα ισχύος. Η προσαρμοσμένη καλωδίωση CURT είναι κατασκευασμένη με μερικές από τις πιο εξελιγμένες τεχνολογίες του κλάδου και έχει σχεδιαστεί για εύκολη εγκατάσταση, παρέχοντάς σας ηλεκτρική σύνδεση μεγάλης διάρκειας για τη ρύθμιση του κοτσαδόρου ρυμούλκησης.

ΚΑΛΥΜΜΑ ΓΙΑ ΤΗ ΣΚΟΝΗ. Για να προωθήσετε τη μακροχρόνια χρήση και την αντοχή στις καιρικές συνθήκες, αυτή η 4πολική καλωδίωση φωτισμού τρέιλερ διαθέτει κάλυμμα από καουτσούκ για τη σκόνη. Προσαρμόζεται εύκολα στην επίπεδη υποδοχή 4 κατευθύνσεων όταν δεν χρησιμοποιείται, προστατεύοντάς την από τα εξωτερικά στοιχεία. ΕΥΚΟΛΟ ΠΡΑΓΜΑ. Η σύνδεση της καλωδίωσης και των φώτων του τρέιλερ είναι εύκολη χάρη στον εργονομικό σχεδιασμό αυτής της πρίζας του οχήματος. Διαθέτει γλωττίδες στο επάνω και στο κάτω μέρος για καλύτερη πρόσφυση κατά τη σύνδεση στο τρέιλερ ή την αποσύνδεση. ΕΙΔΙΚΟ ΟΧΗΜΑ. Αυτή η πλεξούδα καλωδίωσης μετά την αγορά, οχήματος-ρυμουλκούμενου είναι σχεδιασμένη για επιλεγμένα χρόνια των Ford Crown Victoria, Ford Mustang και Mercury Grand Marquis. ΣΤΑΝΤΑΡ ΣΥΝΔΕΣΗ. Αυτή η plug-in καλωδίωση ρυμουλκούμενου 4 επιπέδων μπορεί να χρησιμοποιηθεί για τη σύνδεση πίσω φώτων τρέιλερ, φώτων φρένων και φλας. Η καλωδίωση φώτων τρέιλερ 4 κατευθύνσεων είναι δημοφιλής σε μια ποικιλία τρέιλερ, προσθέτοντας ευέλικτες επιλογές ρυμούλκησης για το όχημά σας. ΕΥΚΟΛΗ ΕΓΚΑΤΑΣΤΑΣΗ. Χωρίς κόψιμο! Χωρίς μάτισμα! Αυτό το κιτ πλεξούδας καλωδίωσης ρυμουλκούμενου συνδέεται στην υπάρχουσα εργοστασιακή καλωδίωση του οχήματός σας και το εξοπλίζει με μια τυπική, πίσω υποδοχή καλωδίωσης ρυμουλκούμενου 4 ακίδων για σύνδεση και ρυμούλκηση τρέιλερ.
Brand CURT
Brand ‎CURT
Country of Origin ‎USA
Customer Reviews 4.2 4.2 out of 5 stars 44 ratings 4.2 out of 5 stars
Is Discontinued By Manufacturer ‎No
Item Dimensions LxWxH 9 x 4 x 2 inches
Item model number ‎55326
Item Weight 0.49 Pounds
Item Weight ‎7.8 ounces
Manufacturer ‎Curt Manufacturing
Manufacturer Part Number ‎55326
Material Rubber
Model ‎Custom Wiring
OEM Part Number ‎55326
Product Dimensions ‎9 x 4 x 2 inches

3.3

9 Review
5 Star
60
4 Star
20
3 Star
10
2 Star
0
1 Star
10

Γράψτε την κριτική σας

Το email σας δεν θα δημοσιευτεί. Όλα τα υποχρεωτικά πεδία επισημαίνονται με*

Scritto da: Romy
Easy to install, but the finished install is jank
Super easy to install, instructions are included but you basically just piggyback this into your rear lights. I think it took like 10 minutes on my 97 Crown Vic. It helps to have some sort of trim removal tool to pop off the plastic clips Ford used to hold the trunk trim up with. It works fine, didn't have to rewire it like some other folks said. Biggest issue I have (which is why it's 4 stars) is that it stays in your trunk until you need it. Like, loose in the trunk. The instructions say something with the gist of 'just sort of tuck it up out of the way someplace.' When you want to use it, you pull it out of the trunk, hook it up to the trailer, and just kind of close the trunk lid on the wires. It's not like the fit and finish on a mid-90s Ford makes this problematic (the wires don't get pinched at all), but it's just jank. They could have routed it through a body plug or something similar (albeit the wires are too short to go through any of the stock body plugs). I'll eventually properly mount this outside the car, but it's going to be a PITA since the connectors will have to be depinned, a hole will need to be drilled, and I'll need to route it all through a grommet that fits said hole. Totally doable, but it's going to take more than 10 minutes.
Scritto da: WEH
Works great!
Fits perfect on my 1995 mustang.
Scritto da: John T. Ertz
Easy to plug in, but was wired wrong.
Very simple to install as stated in the instructions, but as soon as I tested my lights my left signal started flashing fast as though a bulb was burned out, but it was also flashing the side marker light. Disconnected harness and all returned to normal. Broke out test lamp and found that the harness wires from this unit had been improperly placed. In the female connector that plugs to the vehicle wire harness, the Yellow (signal) wire is in the top right, with the Brown (marker lamp) wire in the bottom right. However on the male plug that goes to the taillight and sidemarker, the Yellow and Brown wires are reversed so that the Stop/Turn wire is trying to feed the side marker and the Brown side marker wire is trying to feed the Stop and Turn function. Might want to check that quality control at your Mexican plant and make sure the assembler isn't color blind...
Scritto da: IntoxicatedRedneck
Works
Arrived this evening, I was nervous to open anything from the mail at this point. However, I needed to go pick up my S-10, so I opened it up and found out the harness was real easy to install. I put this in my 96 Mercury Grand Marquis, it basically just snaps into the back of the tail light plugs on the both sides. Takes a minute, hooked up my car trailer, everything worked like it should. Picked up my truck, came back home, everything still works. Its a gud buy.
Scritto da: Yooper-in-gb
Curt 55326 wire harness
This device does not fit a 2004 Mercury Grand Marquis LS as stated on the Amazon parts selector. It only works up to 1997. Curt harness #58044 is for later models and must be spliced in. This(55326) harness just plugs in and looks like a great way to put on a trailer plug. I am sure it works great on the correct model cars. Note for Curt Mfg. - Amazon does NOT download directly from Curt what parts fit each model, so check the Curt site first for compatibility.
Scritto da: joshua
Nice
Work perfectly for mustang 94 convertible V6
Scritto da: Louis c.Brown jr.
Four Stars
thank u
Scritto da: David Plowman
Five Stars
I have not used it yet but think it well work
Scritto da: Amazon Customer
Great price
Quick and easy install

Σχετικά προϊόντα

Ανακαλύψτε το διεθνές μας δίκτυο

Στέλνουμε σε 28 χώρες, πάνω από 200.000 προϊόντα. Μείνετε ενημερωμένοι, εγγραφείτε στο ενημερωτικό δελτίο.

Array